Post Reply 1 post Page 1 of 1
Zebra GX420t Setup
  • User avatar
    Anthony
    Moderator
    Moderator
    Posts: 52
    Joined: Wed Apr 27, 2016 1:53 pm
    Location: Rutland, VT
    Contact:

    Zebra GX420t Setup

    by Anthony » Tue Jun 28, 2016 2:09 pm

    1: Install driver software .

    2: Connect the printer and wait for the printer to install.
    If the Printer is networked see directions below.

    3: Change the driver to the Zdesigner GX420t (EPL)
    Control Panel → Devices and Printers → Right Click on Zdesigner GX420t → select Printer Properties → Advanced → select New Driver → in the Add Printer Driver Wizard select Next → in the Manufacturer list select Zdesigner then in the Printers list select Zdesigner GX420t (EPL) → select Next → select Apply

    4: Verify Communication via Windows Test print.
    Control Panel → Devices and Printers → Right Click on Zdesigner GX420t → select Printer Properties → Select Print Test Page

    5: Download printer stocks from ftp://ftp.highmeadow.com/pub/Support/pr ... ra/Stocks/
    Select Zdesigner Stocks For RetailEdge.drs

    6: Load the Stocks into the Zdesigner GX420t driver.
    Control Panel → Devices and Printers → Right Click on Zdesigner GX420t → Printing Preferences → Import/Export settings → select Import → load the Zdesigner Stocks For RetailEdge.drs file.

    7: Calibrate the Device for the Label Stock you are using.
    Control Panel → Devices and Printers → Right Click on Zdesigner GX420t → Printing Preferences → Options → Stocks: select the Label Stock from the drop down list → select the Advanced Setup verify that Media type is selected to the type of Label you are using, Device options set to None and Top of Form backup is selected → select Calibrate → After Calibrations select Apply → OK.

    6: In RetailEdge select the Zebra GX420t as your Label Printer.
    Tools → Settings → Workstations → Modify → Labels (in 1 of 2 or 2 of 2 depending on your printers use) → select the Zdesigner GX420t from the drop down list → select Save.

    Network Installation

    A: Get the Printers IP Address.
    Make sure the printer is connected VIA Ethernet cable → turn the printer on make sure the light turns Green→ Press the fee label once → Press and hold the feed button again till the light flashes once then release-> The device will now print its configuration information.

    B: Add the printer to your system.
    Control Panel → Devices and Printers → Add a printer → Select the Printer from the List of available printers.
    If the device is not found select The printer that I want isn't listed → Select Add a printer using TCP/IP address or hostname select Next → Change the device type to TCP/IP Device, Hostname or IP Address: enter the printers IP Address (From the Configuration Information printed previously) select Next → Device Type select Standard, in the drop down select Generic Network Card → from the Manufacturer list select Zdesigner, From the Printers list select Zdesigner GX420t → Follow the prompts in the rest of the wizard till the device installs.

    C: Return to Step 3
Post Reply 1 post Page 1 of 1

Who is online

Users browsing this forum: Semrush [Bot] and 1 guest